Unscrew the screws or nuts holding the fixture base to the ceiling box.
Change led ceiling light.
Make sure no one turns on the light while you work.
As an amazon affiliate i get commissions from purchases made from links in the description of my videos.
Grip both sides of the recessed downlight and.
Pull the trim down a few inches.
Very important don t let anyone turn on the light while.
Plug in the replacement light.
Without touching it use your hand to gauge how hot it is.
Once you have done so remove the old bulb from the light fixture.
Replacing a standard light bulb.
Turn off the fixture and allow the bulb to cool.
How to change a ceiling led light bulb recessed downlight step 1.
Squeeze the v springs and remove the light.
Led lights last and that will save you money.
Slide the arms into the brackets inside the housing.
Unplug the old light.
Attach the wires from the new fixture with wire nuts to the corresponding wires in the electrical box.
When it comes to the actual replacement process for your led light bulb you can begin by turning off and unplugging your fixture.
Before changing any light bulb always make sure you ve turned off the light switch.
These new led downlights are really easy.
Place your replacement led bulb in the fixture and screw it into place.
Please help support my channel by using my link to.
Lower the fixture base and remove the electrical tape or wire nuts from the black hot wire white neutral wire and if present green ground wire.
If the light doesn t fit flush try to adjust the rear panel on the housing upwards.
In this video i will show you how to replace remove and install led downlight also known as recessed or can lights.
Push upward until the led light unit clicks into place and the trim is flush with the ceiling.
Get you finger nails between the ceiling and trim and pull down evenly.
Just make sure that you replace your incandescent bulb with a comparable led that will match the performance of the previous bulb.
It s important never to change a light bulb while the lamp is plugged in.
Squeeze the spring arms on each side of the led unit together.